Home > Knowledge > Content

Detailed explanation of the key points of the power control system of the waste paper baler!

Dec 31, 2020

The power control system of the waste paper baler adopts a three-phase four-wire system, which belongs to high-power (referring to how much work an object does in a unit time). For consideration, there are some requirements when operating and using Attention. Mineral water bottle packing machine This product has the characteristics of good rigidity, toughness and stability, beautiful appearance, convenient operation and maintenance, safety and energy saving, and low investment cost of equipment basic engineering. It is widely used in all kinds of waste paper factories, waste recycling companies and other units and enterprises. It is suitable for the packaging and recycling of waste paper, plastic straw, etc. It is a good equipment to improve labor efficiency, reduce labor intensity, save manpower, and reduce transportation costs. Let me tell you one by one!

1. It is recommended to use three-phase four-wire system for the input power of the waste paper baler, and compare grounding protection before use. It is recommended to use a 3×35+1×10 mm2 cable for the input lead.

2. Before starting the main motor, check whether each operating control component is in the reset state. With the increasing awareness of environmental protection, the waste paper baler has played a very important role. It can reuse some waste paper and is more and more accepted by everyone. In constant innovation, we are constantly following the development of some foreign advanced technologies.

3. When starting the main motor, press the "Main motor start" button first, and then press the "Main motor stop" button to observe whether the rotation direction of the main motor matches the direction indicated on the label. If not, the waste paper baler should adjust the three-phase power supply Phase make it.

        Remember: When the motor rotates in the opposite direction to the indicated direction, the time cannot exceed 2 seconds, otherwise the main oil pump will be damaged. The waste paper baler is used to squeeze waste paper and similar products under normal conditions and pack them into a special packaging belt to greatly reduce the volume, thereby reducing transportation volume, saving freight, and increasing benefits for enterprises. The introduction of advanced technology and advanced technology of similar products at home and abroad.

     

4. For electrical systems with phase failure and phase sequence protection, when the main motor does not work after pressing the "Main Motor Start" button, you can switch any two wires of the three-phase wire to each other to start normally.