The semi-automatic waste paper baler adopts the integrated control of liquid and electricity. It is simple and convenient to use. It can be stopped and run at any working position. It is easy to achieve packaging. Features of the semi-automatic waste paper baler. Integrated circuit design: New type of waste paper baler circuit design, using plug-in The circuit board controls the entire packing action and the temperature of the ironing head, and the circuit board replacement is quite convenient. The compression frame of the semi-automatic waste paper baler is basically similar in structure to the compression frame, but there are 4 packing heads and 1 thread feeding device arranged on it. The semi-automatic waste paper baler baling heads (4 in total) are the parts of the whole equipment with a more complex structure and more chain actions. Each semi-automatic waste paper baler has exactly the same structure and can be interchanged.
There are 4 sets of feeding devices for the semi-automatic waste paper baler, each of which corresponds to a baling head. Each set includes a baling line conveying device and a baling line reverse tension device. The main rail seat of the semi-automatic waste paper baler is mainly composed of two wear-resistant steel rails on the surface. The wheels of the compression frame are guided to run along the outer sides of the two tracks, and hydraulic cylinders that push the compression frame to operate are arranged in them. In addition, there is a complete set of hydraulic stations in addition to mechanical components. It can be seen from the above description that the various movements of the semi-automatic waste paper baler are completed by fluid power. The waste paper baler is used to squeeze waste paper and similar products under normal conditions and pack them into a special packaging belt to greatly reduce the volume, thereby reducing transportation volume, saving freight, and increasing benefits for enterprises. The introduction of advanced technology and advanced technology of similar products at home and abroad. Instant heating, immediate packaging: the first fast-heating system hot-melt design, the hot film can work within 5 seconds, and enter a better packaging state. Automatic stop device, semi-automatic waste paper baler saves electricity and is practical: when the bundling action is completed and the operation control is no longer within 60 seconds, the motor and engine will automatically stop and enter the standby state. New type of brake design: The brake with disc of this machine adopts a special spring design to ensure smooth and no noise. The production process of direct reduced iron can be divided into the following five processes: 1. Hot metal. Raw material preparation and drying and crushing process: Put desulfurization (chemical symbol: S) agent and reducing agent into a quantitative hopper, quantitative hopper According to the weight ratio of the two materials, the materials are sent to the drying chamber through the conveyor to dry and mix the two materials. The moisture content of the dried material is less than 3%. The dried material is sent to the reducing agent crusher through a conveyor for crushing, and the crushing particle size is less than 1.5mm.
The semi-automatic waste paper baler puts a layer of packing cloth on the bottom of the baler before packing, then closes the packing case, and presses it several times by manual filling, and then puts a layer of packing on the top of the bale before pressing once. Then use a baler to compact the stalks (introduction: mature crop stems and leaves), open the baler door, manually tie the wire, return the baler head, and push the bale out of the baler. The semi-automatic waste paper baler is characterized by low price, but the disadvantage is low efficiency related machines.