Home > Knowledge > Content

Talking about the solution to the oil leakage of the waste paper baler

Dec 16, 2020

      Waste paper baler has good rigidity, toughness and stability, beautiful appearance, convenient operation and maintenance, energy saving, and low investment cost of equipment basic engineering. It is widely used in all kinds of waste paper factories, waste recycling companies and other units and enterprises. It is suitable for the packaging and recycling of waste paper, plastic straw, etc. It is a good equipment to improve labor efficiency, reduce labor intensity, save manpower, and reduce transportation costs.


  The waste paper baler sometimes has oil leakage during its work. Here are some ways to avoid it.


1. Poor heat dissipation, insufficient heat dissipation area of the fuel tank, too little oil storage in the fuel tank, resulting in too fast oil circulation, poor cooling of the waste paper packer cooler, such as failure of cooling water supply or failure of electric fans, high ambient temperature, etc. All are the reasons for poor heat dissipation.


  2. The oil disclosure of the waste paper baler is more serious. That is because the pressure of the waste paper baler oil pump is adjusted too high, which will cause serious wear of the movable parts and increase the gap, the seal installation is destroyed, the viscosity of the oil used in the waste paper baler is too low, etc., will increase the disclosure. After knowing this reason, it can be solved accordingly.


  3. When the waste paper baler is working, it is not allowed to use oil with too high viscosity, which will cause excessive hydraulic pressure of the waste paper baler.


4. When the waste paper baler system has no unloading circuit or the unloading circuit is bad, when the waste paper baler system does not use pressure oil, the oil is still overflowing to the fuel tank or under the working pressure set by the overflow valve. The environment with higher unloading pressure is returned to the fuel tank downstream. It is necessary to check whether the unloading circuit is normal for the waste paper baler.