Home > Knowledge > Content

​When cleaning the waste paper baler, you should pay attention to the content. Everyone has a look!

Dec 31, 2020

Guide: You should pay attention to the content when cleaning the waste paper baler. Everyone has a look!

        The cleaning operation of the hydraulic system of the waste paper baler is true for the baler, because the waste paper baler needs a good hydraulic system when working. With the increasing awareness of environmental protection, the waste paper baler has played a very important role. It can reuse some waste paper and is more and more accepted by everyone. In constant innovation, we are constantly following the development of some foreign advanced technologies. The lead frame of the automatic waste paper baler is composed of 4 sets of wire devices installed on a frame. The entire lead frame is suspended on a central axis of the compression frame, and moves horizontally relative to the compression frame under the action of a hydraulic motor. The compression frame is a welded component, and the bottom is equipped with wheels, which can move horizontally along the main slide rail under the push of a hydraulic cylinder. The lifting platform is mainly formed by bolting two horizontal beams, and the lifting platform can move up and down in the vertical direction under the push of two hydraulic cylinders. Therefore, in daily work, the cleaning of the baler should not be underestimated and should be taken seriously. Where can be cleaned and where can not be cleaned, we have to figure out the situation. Below, let’s take a look at the points of attention for cleaning the waste paper baler:

       First, use a low-viscosity clean oil. When cleaning, add the oil to the fuel tank of the straw (introduction: mature crop stems and leaves) baler and heat it to 50-80 degrees Celsius (℃). The automatic waste paper baler is a mechatronic product, mainly composed of mechanical systems, control systems, feeding systems and power systems. The whole packing process is composed of auxiliary time such as pressing, returning, carrying, transferring, outgoing up, outgoing down, and receiving. Start the hydraulic pump and let it run dry. When cleaning, you should always tap the tube gently. The purpose of this is to remove the attachments. Clean the oil filter for 20 minutes to check the infection status, and clean the filter, and then clean it again. Repeat until the filter Stop when there are not too many pollutants. The cleaning time of the waste paper baler is generally 2 hours. For the more messy hydraulic system, each area can be cleaned according to the work area. The hydraulic cylinder can also be connected to allow the hydraulic cylinder to reciprocate to clean the system. After cleaning, drain the cleaning oil as much as possible and clean the oil tank. Then remove the temporary cleaning circuit, restore the waste paper baler system to normal operation, and add the specified hydraulic oil.