The semi-automatic waste paper hydraulic baler control system is composed of the core control unit PLC and the operating human-machine interface. The core control unit is controlled by LGPLC. The semi-automatic waste paper hydraulic baler system is the core part of the pressurized packaging machine, and its working reliability is directly determined Whether the operation of the packaging machine is normal, the oil temperature control is the key to the control part of the semi-automatic waste paper hydraulic baler
Why should the semi-automatic waste paper hydraulic baler be moisture-proof?
Overview The semi-automatic waste paper hydraulic baler should pay attention to the reasons for moisture prevention and its appropriate application operation process. There are reasons to avoid the entry of water:
1. Water corrodes the metal material and polymer material in the system software of the semi-automatic waste paper hydraulic baler drive system, reducing the service life of electronic components, and the eroded fine particles fall into the system software and cause damage.
2. The semi-automatic waste paper hydraulic baler speeds up the growth of oil and mildew, and there are fine particles such as iron, copper, manganese, etc., and the oxygen in the water and air oxidizes the oil and air and converts it into thick polymer, collectively called oil stain . When the application temperature exceeds 65 degrees, the air oxidation rate accelerates, and the chemical effect doubles for every 10 degrees increase.
3. The wettability of the semi-automatic waste paper hydraulic baler is reduced. When using the plastic strapping of the automatic waste paper strapping machine, it is not necessary to make the plastic strapping dirty and damaged. If you pay a little attention, it is generally not easy to get dirty. However, there is a situation that should be paid attention to. After the belt was finished, I forgot to close the door of the storage box of the semi-automatic waste paper hydraulic baler, and immediately pressed the function button of the belt feeding, causing all the plastic packaging belts to fall to the ground. Therefore, it is stipulated that the operation procedure must be used when working careful.