Home > News > Content

Emergency Treatment Method Of Waste Paper Baler In Operation

Sep 28, 2020

Emergency treatment method of waste paper baler in operation

 

       1. Check the operation of the pump. If the small waste paper baler is noisy, the needle swing is large, and the oil temperature is too high, the pump may be severely worn.

       2. Understand the operating efficiency of the pump. Comparing the temperature of the pump casing and the fuel tank, if the temperature difference between the two is higher than 5°C, the pump efficiency can be considered very low.

       3. Check the oil leakage of the pump shaft and joints, pay special attention to leakage when the temperature is high and high pressure.

       4. Observe the indication value of the vacuum gauge installed at the suction pipe of the pump. During normal operation, its value should be below 127mmhg; otherwise, check the oil filter and working oil of the small waste paper baler.

       A small amount of air has penetrated into the waste paper baler oil, and needle-shaped bubbles can be found in the oil tank. If a lot of air invades the system, a lot of bubbles will appear in the fuel tank. At this time, the oil is easily deteriorated and cannot be used. At the same time, the hydraulic system of the waste paper baler equipment will experience vibration, noise, pressure fluctuations, unstable operation of hydraulic components, crawling of moving parts, reversing impact, inaccurate positioning or disordered movement.