How does the automatic baler work
Compared with semi-automatic packing machine, the automatic packing machine has one more frame. It does not need people to guide the belt manually. As long as the packing is placed on the machine table and the switch is pressed, the packing can be automatically packed. The continuous packing method can also be used, and only people need to turn the packing. Yes, the structure is much more complicated than semi-automatic. There are only three motors and the efficiency is quite high. However, the requirements for the strapping are high. Harder and straighter strapping must be used, or there are many problems.
The packaged object is basically in the middle of the baler. First, the right top body rises, and the front end of the belt is compressed, and the belt is tightened to the object. Then the left top body rises, compresses the appropriate position of the lower belt, and the heating sheet extends into the middle of the two belts. , The middle top knife rises, cuts off the strap, and finally sends the next strapping into place, completing a work cycle.
The baler is a machine that uses a packing tape to wrap the product or package, then tighten it and fuse the two ends through a thermal effect or use a buckle and other materials to connect the machine.
The function of the baler is to make the plastic belt close to the surface of the bundled package to ensure that the package is not scattered due to improper tying during transportation and storage. At the same time, it should be tied neatly and beautifully.