Home > News > Content

How Much Is A Waste Paper Baler?

Oct 14, 2020

      In the usual application of waste paper baler, pay attention to the touch screen of the fully automatic baler equipment, and ensure the following content requirements:


   There is no need to open the back shell of the waste paper packer touch screen. Do not place magnets, motors and other magnetic objects close to the touch screen. Do not use hard objects to touch the surface of the control screen. Do not splash the etch liquid on the touch screen. Before installing, disassembling and cleaning the waste paper packer and touch the screen, the power should be cut off. Regularly maintain the vents on the rear shell of the waste paper packer touch screen to keep the vents smooth.


The key to the common failures of the gasoline pump of the waste paper baler that does not leak oil are the common failures of the gasoline pump, the common failures of the oil suction pipe, the common failures of the fuel tank filter device, and the common failures of the oil pump motor. If the gasoline pump of the waste paper baler does not leak, the common failures are as follows Ways to check failure detection successively.


   1. If the rotation position is incorrect, stop immediately, change the rotation position of the motor, if it will burn out or damage the gasoline pump again.


  2. The gasoline pump of the waste paper packer does not rotate. Repair the coupling.


   3. The pump shaft is broken and the motor rotor does not rotate. Repair the gasoline pump.


   4. The suction pipe is blocked, check the suction pipe.


  5. The filter device of the fuel tank is blocked, clean the filter device or replace it.


  6. The volume of the fuel tank filter device is not enough to replace the large volume, which is about twice the pump volume.


  7. The viscosity of No. 46 hydraulic oil of the waste paper baler is too high. Remove the oil and set the electric heater.


   8. The rated power of the waste paper baler motor is not enough, and the speed required for the replacement of the gasoline pump is higher than the motor.


  9. The suction pipe of the gasoline pump is not well-sealed, and the suction pipe appears as a result of steam inspection.


  10, the oil tank filter device is higher than all the oil supply or redesign the oil surface aspect ratio.


  11. The gasoline pump blade cannot slide out of the rotor groove of the motor. Repair the gasoline pump or disassemble the gasoline pump.