Home > News > Content

How To Adjust The Waste Paper Baler To Make It Beneficial To Our Production?

Dec 28, 2020

        We have specially made all kinds of horizontal waste paper balers for you, but we are not able to know what to produce and how to adjust the waste paper balers. The method is handed over to you to facilitate the packaging of different materials in the future. Mineral water bottle packing machine This product has the characteristics of good rigidity, toughness and stability, beautiful appearance, convenient operation and maintenance, safety and energy saving, and low investment cost of equipment basic engineering. It is widely used in all kinds of waste paper factories, waste recycling companies and other units and enterprises. It is suitable for the packaging and recycling of waste paper, plastic straw, etc. It is a good equipment to improve labor efficiency, reduce labor intensity, save manpower, and reduce transportation costs. The waste paper baler is used to squeeze waste paper and similar products under normal conditions and pack them into a special packaging belt to greatly reduce the volume, thereby reducing transportation volume, saving freight, and increasing benefits for enterprises. The introduction of advanced technology and advanced technology of similar products at home and abroad. How do we adjust the horizontal waste paper baler in life? Take a look together:

       

        1. Belt width and joint adjustment. When the belt width is uneven or the belt is changed to another width, it is difficult to insert the belt when the left and right belt insertion slots are too narrow; when it is too wide, the horizontal waste paper baler will pack The joints of the back straps will not overlap. There are 4 sets of feeding devices for the scrap metal baler, each of which corresponds to a baling head. Each set includes a baling line conveying device and a baling line reverse tension device. The main rail seat of the waste paper hydraulic baler is mainly composed of two wear-resistant steel rails on the surface. The wheels of the compression frame are guided to run along the outer sides of the two tracks, and hydraulic cylinders that push the compression frame to run are arranged therein. In addition, there is a complete set of hydraulic stations in addition to mechanical components. It can be seen from the above description that various movements of the waste paper hydraulic baler are completed by fluid power. Generally, the width of the belt slot should be about 0.5-1 mm wider than the belt width.

       2. Adjusting the temperature of the ironing head of the horizontal waste paper baler. The temperature of the ironing head has a great influence on the quality of the belt joint. In order to make the polypropylene strap joints stick firmly, the knob is generally placed in the 3-5 position. Whether the temperature of the ironing head is, you can inspect the surface adhesion of the ironing head. If there are white marks on the surface of the iron, the temperature is already too high; if the surface of the iron is moist, the temperature is insufficient.

       3. Tightening adjustment of the strapping of the horizontal waste paper baler Open the decorative panel of the table, and loosen the hexagonal socket set screw on the big Luo mother A by hand. The clockwise direction is tightened, and vice versa. After the binding force is moderate, tighten the hexagon socket set screw.

           4. Adjusting the length of the feeding belt The length of the feeding belt is determined by the feeding length adjuster on the front decorative panel. If the belt is too short, it is easy to tie your hands. At this time, the horizontal waste paper baler can hold the belt head and pull the belt out along the belt feeding direction. But you need to readjust the length of the feeding belt, and the strapping will proceed normally. If the belt of the horizontal waste paper baler is too long, it is difficult to align the position, and the belt of the horizontal waste paper baler is easy to be wound together and cause the belt to be misaligned or broken.