Home > News > Content

Nantong Hydraulic Baler Can Be Customized According To Actual Production Needs

Dec 14, 2020

    All hydraulic baler equipment produced by our company is hydraulically driven, and can be manually or automatically controlled according to actual needs. The forms of package delivery include various methods such as turning over, pushing and manually taking packages.


    The hydraulic baler has a self-fixing device, which does not require foot screws for fixing during installation. And when there is no power source, a diesel engine can be selected as the power source. The pressure section can be selected from 63 tons to 400 tons. If customers have requirements for compressed size, they can also customize the compression chamber.


   In the near future, our hydraulic baler will gradually move towards high speed, high efficiency and low energy consumption, which can better improve the working efficiency of hydraulic baler and reduce production costs. The integrated operation of electro-hydraulic can make full and reasonable use of advanced mechanical and electronic technology to promote the perfection of the hydraulic system.


1. Please confirm the power supply used by the machine, and do not insert the wrong power supply. This machine adopts a three-phase four-wire system. The patterned wire is a grounded neutral wire for leakage protection.


2. Do not cross the track with your head and hands during operation;


3. Do not touch the heating plate directly with your hands;


4. Do not wash the machine with water. When the workplace is wet, operators should not work barefoot;


5. When the machine is not in use, please rewind the tape in the storage bin to the reel to avoid deformation during the next use;


6. Do not stick oil on the surface of the conveyor roller;


7. Remember to unplug the power when the machine is not in use;


8. Do not change the parts on the machine at will;


9. The main parts should be lubricated with oil frequently. Hydraulic baler


Maintenance method: check whether the working pressure is normal;


The cutting force of the steel belt comes from the blockade of the cylinder, see the fault phenomenon;


Check block operation


Trouble: The pulling force of the locking clip is not enough hydraulic baler


Reason: the connecting hole of the clamping block or the connecting pin is worn


Repair method: check these parts when the groove depth is shallow, replace if necessary