Home > News > Content

Precautions During Installation Of Hydraulic Oil Pump Of Industrial Waste Paper Baler

Nov 09, 2020

1. The pros and cons of the installation and use of hydraulic oil pumps have a very important impact on the stable operation and service life of the pump. Therefore, the installation, calibration and operation must be carried out carefully and not rashly. The support frame or base of the hydraulic oil pump must be strong and stable, and the pump shaft of the hydraulic oil pump must be well aligned with the motor.


2. The installation relative height, length and pipe diameter of the suction pipe of the hydraulic oil pump should meet the calculated value, strive to be short and reduce unnecessary losses; and ensure that the pump does not exceed its allowable cavitation allowance during operation. The inner diameter of the suction pipe should not be lower than the specified requirements. The suction pipe should not be too long. The 90-degree bend should not exceed two. If it is connected to the inlet of the hydraulic pump with a soft short connection, the hydraulic pump should be installed at a relative height so that the hydraulic oil can flow by itself The suction port of the oil pump is suitable.


3. The suction and discharge pipes of the hydraulic oil pump should have support frames, which are not allowed to bear the load of the pipes.


4. The place where the hydraulic oil pump is installed should be spacious enough to facilitate maintenance and operation