An industry needs the assistance of another industry. An industry cannot develop and cannot be taken care of. There is room for the development and development of waste cardboard balers. With the material and cultural needs of waste cardboard and modern logistics, more and more waste cardboard The baler is used in our daily lives. There are also more and more discarded packages. Therefore, from the current and future development situation, waste cardboard baler equipment has broad market space and industry development prospects. What should you pay attention to during the packaging process of waste cardboard baler equipment:
1. The oil supply system of the waste cardboard baler equipment should be in accordance with the quantity specified in the foregoing description plus the specified working oil. The oil temperature should not exceed 50-70℃.
2. In the oil supply system of the waste cardboard baler:
①The crude oil is cleaned every month within half a month of the new installation, filtered by a 120-150 mesh filter, and then added to the fuel tank.
② After three months, pump out the hydraulic oil and clean the oil tank.
③ Clean the oil filter every production quarter after three months of normal use.
3. After adjusting the overflow valve, unloading valve, and stroke switch of the baler, measures should be taken to avoid accidents. As the awareness of environmental protection is getting heavier and heavier, the waste cardboard baler has played a very important role. It can reuse some waste paper, and it is more and more accepted by everyone. Domestic waste cardboard The baler has been constantly innovating and following the development of some foreign advanced technologies.
4. The lubricating grease in the bearing should be changed every year during the careful inspection and maintenance of the baler equipment.
5. Non-operators are strictly forbidden to operate. When feeding, remove the handle and then press and compress. Operators pay attention.
6. It is strictly forbidden to load heavy packages. The compression frame of the mineral water bottle packing machine is basically similar in structure to the compression frame, but there are 4 packing heads and 1 set of thread feeding device arranged on it. The baling heads of the waste paper hydraulic baler (4 in total) are parts of the entire equipment with a very complex structure and a lot of action chains. The baling heads of each hydraulic baler are completely the same in structure and can be interchanged.
7. After the filling is completed, the material exposed from the material box should be stepped on to the upper part of the material box, otherwise it may cause the cylinder to bend or the pressure plate to deform. The waste cardboard baler is used to squeeze waste paper and similar products under normal conditions, and pack them into a special packaging tape to greatly reduce the volume, thereby reducing transportation volume, saving freight, and increasing benefits for enterprises . The introduction of advanced technology and advanced technology of similar products at home and abroad.